Wasp-barcode WDI4600 2D Product Reference Guide Manuale Utente Scaricare il pdf (Pagina 13)

About the Reader Introduction

Product Reference Guide

About the Reader

Typically, units are factory-programmed for the most common terminal and communications

settings. If you need to modify any programmable settings, custom configuration can be

accomplished by scanning the programming bar codes within this guide.

Advancements in the LED technology used in the imager-based readers significantly improve

the illumination

of the target field of view, resulting in higher scan efficiency. Whether used in

Single Trigger or Continuous Mode, the ergonomic design of the reader will help to promote

comfortable handling during extended periods of use.

See "Interface Selection" on page 8 for a listing and descriptions of available interface sets by

model type.

Programming the Reader

Configuration Methods

Programming Bar Codes

The reader is factory-configured with a standard set of default features. After scanning the

interface bar code, you can select other options and customize your reader through use of the

instructions and programming bar code labels available in the corresponding features section for

your interface. Customizable settings for many features are found in "Configuration Parameters"

starting on page 15.

Some programming labels, like "Restore Custom Defaults" on page 13, require only the scan of the

single label to enact the change. Most, however, require

the reader to be placed in Programming

Mode prior to scanning them. Scan an ENTER/EXIT bar code once to enter Programming

Mode. Once the reader is in Programming Mode, scan a number of parameter settings before

scanning the ENTER/EXIT bar code a second time, which will then accept your changes, exit

Programming Mode and return the reader to normal operation.

There are some exceptions to the typical programming sequence described

above. Please read the description and setting instructions carefully when

configuring each programmable feature.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 283 284

Nessun commento

Wasp-barcode WDI4600 2D Product Reference Guide Manuale Utente Pagina 13