Wasp-barcode WLS9600 Product Reference Guide Manuale Utente Scaricare il pdf (Pagina 249)

Keyboard Interface

Product Reference Guide

239

Keyboard Interface

Wedge Quiet Interval

Specifies the amount of time the reader looks for keyboard activity before it breaks the keyboard

connection in order to transmit data to host. The range is from 0 to 990ms in 10ms increments.

This feature applies ONLY to the Keyboard Wedge interface.

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Go to page 40 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Prog. Mode.

4. Scan the barcode: SELECT WEDGE QUIET INTERVAL SETTING.

5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.

This completes the procedure to set the Wedge Quiet Interval. See Ta ble 35 for some examples

of how to set this feature.

Table 35. Wedge Quiet Interval Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

10ms 150ms 600ms 850ms

Divide by 10 (and pad with

leading ze

roes)

01 15 60 85

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT WEDGE QUIET INTERVAL SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘1’ ‘1’ and ‘5’ ‘6’ and ‘0’ ‘8’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 305 306

Nessun commento

Wasp-barcode WLS9600 Product Reference Guide Manuale Utente Pagina 249