Wasp-barcode WLS9600 Product Reference Guide Manuale Utente Scaricare il pdf (Pagina 267)

Scanning Features

Product Reference Guide

257

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable

range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.

Follow these instructions to set this feature.

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with

leading z

eroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Go to page 75 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT FLASH OFF TIME SETTING.

5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 44 for some examples of how to set this feature.

Table 44. Flash Off Time Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

500ms 1,000ms (1 sec.) 5200ms (5.2 sec.) 9,900ms (9.9 sec.)

Divide by 100 (and pad with

leading zer

oes to yield two

digits)

05 10 52 99

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT FLASH OFF TIME SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘5’ ‘1’ and ‘0’ ‘5’ and ‘2’ ‘9’ and ‘9’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 305 306

Nessun commento

Wasp-barcode WLS9600 Product Reference Guide Manuale Utente Pagina 267